Empress-effects Phaser User Manual download pdf (Page 17)

Expression Pedal Configuration

The pedal ships in this configuration. Plug an expression pedal into

the control port, and use the expression switch to select which

parameter you’d like to control with the pedal. You can select speed

or width when using knob and tap modes. In auto mode the speed

and width switch positions will control sensitivity and release,

respectively. The expression pedal varies the parameter between

zero (or fully counter-clockwise) and the setting on the knob. In

other words, the knob sets the maximum.

Any expression pedal used with the Empress Phaser should have:

Tip - signal

Ring - power

Sleeve - ground

Control Voltage Configuration

In this configuration, width and speed parameters can be controlled

by an external control voltage. The Empress Phaser works with

control voltages which sweep between 0V and 5V.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Empress-effects Phaser User Manual Page 17