Empress-effects Phaser User Manual download pdf (Page 7)

Sensitivity

The sensitivity knob controls how the pedal listens to your input

signal when in auto mode. For softer input signals you should set

the sensitivity to a higher value. For louder input signals it should be

turned down.

In an auto mode that uses trigger detection, the red LED above the

tap switch indicates that a trigger has been detected. If you find the

auto mode is missing some of the triggers, increase the sensitivity. If

you find the auto mode is triggering when it shouldn’t be, decrease

the sensitivity.

When the pedal is in a submode that uses envelope detection the

red LED above the tap switch will light up when it is detecting

maximum volume. Ideally, in envelope based submodes, the LED

will only light up when you’re playing your absolute loudest. This

will ensure you are experiencing the full range of parameter sweep.

Setting the expression switch to ‘speed’ will allow you to control the

sensitivity with an expression pedal.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Empress-effects Phaser User Manual Page 7